KSJB Series Dual Phase DC Output SSR

· MOSFET Output
· Low Impedance
· Control Voltage: 4-15VDC or 15-32VDC
· Internal Over-voltage Protection
· Photoelectric Isolation
· Dielectric Strength: 2500Vrms
· Panel Mount
· LED Indicator
· RoHS Compliant

KSJB Series Dual Phase DC Output SSR.pdf

General Notes
1.The heat generated by the relay needs to be dissipated through the bottom plate, and it is necessary to ensure that the relay base plate is in close contact with the heat sink and installed firmly, and the contact surface needs to be covered with thermal pad or thermal grease.
2.The relay terminal should ensure that the wiring is firm because the loose wiring will cause the product to heat up abnormally and damage the product. The recommended installation torque for M3 terminals is (0.2~0.5)N·m, and for M4 terminals the recommended installation torque is (0.98~1.37) N·m.
3.When the ambient temperature is high, please refer to the temperature curve to derate.
4.For the capacitive load, at the moment of turning on, an extremely high inrush current will happen, which may cause SSR to be damaged due to excessive inrush current. Therefore, if the load is a capacitive load, or if the load is equipped with a large
capacitor in parallel, it is strongly recommended to connect the NTC in series in the load circuit to suppress the inrush current to avoid damage to the product.